It is of vital importance, before attempting to operate your engine, to read the general 'SAFETY INSTRUCTIONS AND WARNINGS' section on pages
Glowplug lifeParticularly in the case of very high performance engines, glowplugs must be regarded as expendable items. Fit a plug suitable for the en
Apart from when actually burned out, a plug may need to be replaced because it no longer delivers its best performance, such as when:When to replace t
BATTERY LEADSThese are used to conduct current from the battery to the glowplug. For convenience,special leads with a suitable clip to fit the glowplu
The somewhat violent changes of vehicle attitude that occur in off-road running, combined with the fact that, in buggy type cars, the fuel tank is oft
DO NOT energize glowplug, but apply electric starter to draw fuel to carburetor.Now connect glowplug battery lead to heat the plug filament and start
If the engine should need to be disassembled (e.g. for cleaning or minor parts replacement) it is advisable to return the Needle-Valve to the original
Run the vehicle (with throttle fully open) over the longest available straight course, in order to observe the model's speed. Next return the car
With the optimum mixture control position, light smoke is visible during high speed running,and the engine revolutions increase smoothly during accele
REALIGNMENT OF MIXTURE CONTROL VALVE In the course of making carburetor adjustments, it is just possible that the Mixture Control Valve may be inadver
4.Then, inject some after-run oil into the engine, and rotate the engine with an electric starter for 4 to 5 seconds to distribute the oil to all the
CONTENTSSAFETY INSTRUCTIONS AND WARNINGS ABOUT YOUR O.S. ENGINEINTRODUCTION, BASIC ENGINE PARTSENGINE SHIELD, INSTALLATION THROTTLE LINKAGEAIR CLEANER
MAX-12, 15LD/LD(T) EXPLODED VIEWType of screw C…Cap Screw M…Oval Fillister-Head ScrewF…Flat Head Screw N…Round Head Screw S…Set Screw 1234567890-=
MAX-12,15LD/LD(T) ENGINE PARTS LISTThe specifications are subject to alteration for improvement without notice. 104 Filter Elements (3pcs.)Screw SetGl
MAX-12, 15LD-X/LD-X(T) EXPLODED VIEWType of screw C…Cap Screw M…Oval Fillister-Head ScrewF…Flat Head Screw N…Round Head Screw S…Set Screw 12345678
MAX-12,15LD-X/LD-X(T) ENGINE PARTS LISTThe specifications are subject to alteration for improvement without notice.DescriptionCode No.No.5 Recoil Star
The specifications are subject to alteration for improvement without notice.Type of screw C…Cap Screw M…Oval Fillister-Head ScrewF…Flat Head Screw N
RACING ENGINE PARTS(21325000)O.S. GENUINE PARTS & ACCESSORIES O.S. Glow Plug(71608001)(71605300)(71605100)No.8A3A5 (72403420)104 Filter Elements(3
414-M3x0.55.5231815.715.746.622.3M5x0.8 Displacement Bore Stroke Practical R.P.M. Power output WeightMAX-12LD SPECIFICATIONS12/15LD THREE V
M5x0.81835.74123.34-M3x0.55.52315.715.746.617.3412/15LD-X THREE VIEW DRAWINGDimensions(mm) Displacement Bore Stroke Practical R.P.M. Power outpu
MEMO28
C Copyright 2000 by O.S.Engines Mfg. Co., Ltd. All rights reserved. Printed in Japan.UNEQUALLEDQUALITYPRECISION&PERFORMANCEESTABLISHINGTHESTANDAR
Remember that your engine is not a "toy", but a highly efficient internal-combustion machine whose power is capable of harming you, or other
WARNINGSModel engine fuel is poi-sonous. Do not allow it to come into contact with the eyes or mouth. Always store it in a clearly marked container an
This engine is intended for model cars. Do not attempt to use it for any other purpose.Mount the engine in your model securely, following the manufact
NOTESTo stop the engine, fully retard the throttle stick and trim lever on the trans-mitter, or, in an emergency, cut off the fuel supply by pinching
INSTALLING THE GLOWPLUGFit washer to glowplug and insert carefully into cylinder-head, making sure that it is not cross-threadedbefore tightening firm
INSTALLATION OF E-1000 SILENCER (12/15LD(T).LD-X(T))Fit the nipple (supplied) to the silencer, applying heat-resistant epoxy sealant at the roor of th
••••◆◆◆NOTES CONCERNING THE RECOIL STARTER( 12/15LD-X ONLY)REMINDER!◆◆Do not attempt to disassemble the recoil starter. If you do so, the very strong
Comentários a estes Manuais