Os-engines FS-200S-P Manual do Utilizador

It is of vital importance, before attempting to operate your engine, to read the general 'SAFETY INSTRUCTIONS AND WARNINGS&apos

18NEVER disassemble the fuel pump or pressure regulator. Their original performance may not be restored after reassembly.DO NOT allow forei

20RUNNING-IN ("Breaking-in")For long life and peak performance, every engine needs special treatment when new, know as “running-

22In the course of making carburetor adjustments, it is just possible that the Mixture Control Valve setting may be upset.Its basic setting ca

24MAINTENANCEPlease pay attention to the matters described below to ensure that your engine serves you well in regard to performance,

26Type of screw C...Cap Screw M...Oval Fillister-Head ScrewF...Flat Head Screw N...Round Head Screw S...Set ScrewENGINE EXPLODED VIEW79871020798710

2811-11-21-31-41-523455-15-2677-1892388190022681980249818372638150127381940267113052268195344582100455818204458160046066319248818244458220027881400220

3032.4 cc / 1.98 cu.in.38.0 mm / 1.50 in.28.6 mm / 1.13 in.1,800 - 10,000 r.p.m.3.0 ps / 9,000 r.p.m.876 g / 30.9 oz.116g (4.1 oz.)58642550~7037776597

2Remember that your engine is not a " toy ", but a highly efficient internal-combustion machine whose power is capable of

4Take care that the glow plug clip or battery leads do not come into contact with the propeller. Also check the linkage to the throttle arm. A disconn

6ABOUT THE ENGINESTANDARD ACCESSORIESNeedle Valve Extension Cable SetThis is an overhead valve four stroke cycle engine for model aircraft use.

8Make sure that the tank is well rinsed out with methanol or glow fuel before installation and that the pickup weight is well clear of the botto

10It is suggested to use Lock Washers (available as an optional extra) with engine installing screws or apply LOCTITE to the screws to prevent them fr

12M2.6x12IInstall these in the following sequence.Screw the exhaust header pipe into the exhaust port until it “bottoms”, then unscrew it approxim

14Install the prop to the engine shaft, followed by the retaining washer and prop nut and tighten firmly with a 14mm wrench. (not supplied).2

16GLOWPLUGThe role of the glowplugGlowplug lifeParticularly in the case of very high performance engines, glowplugs must be regarded as expenda