Os-engines 21RG-X Manual do Utilizador Página 1

It is of vital importance, before attempting to operate your engine, to read the general 'SAFETY INSTRUCTIONS AND WARNINGS' section on pages

18 IF THE ENGINE FAILS TO STARTCheck the following:Glowplug battery discharged or glowplug defunct.Fuel not reaching carburetor.Engine flooded. Do not

20CARBURETOR CLEANLINESSThe correct functioning of the carburetor depends on its small fuel orifices remaining clear.(See Care and Maintenance section

224.Then, inject some after-run oil into the engine, and rotate the engine with an electric starter for 4 to 5 seconds to distribute the oil to all th

2421RG, 21RG(P) ENGINE EXPLODED VIEWC.M2.6x15123445678910111212-A131415C.M2.6x18C.M2.6x7C.M3x8Type of screw C...Cap Screw M...Oval Fillister-Head Scr

2621RG-X, 21RG(P)-X ENGINE EXPLODED VIEWType of screw C...Cap Screw M...Oval Fillister-Head ScrewF...Flat Head Screw N...Round Head Screw S...Set S

2811-11-2233-13-23-33-44567891011C.M2.6x7Type of screw C...Cap Screw M...Oval Fillister-Head ScrewF...Flat Head Screw N...Round Head Screw S...Set

3029.645214- 3.333.510.5375480.795.84084 (65.6)UNF1/4-28443.46 cc / 0.211 cu. in16.6 mm / 0.654 in16.0 mm / 0.630 in3,000-35,000 r.p.m.1.9 ps / 30,0

!!2Remember that your engine is not a "toy", but a highly efficient internal-combustion machine whose power is capable of harming you, o

!4This engine is intended for model cars. Do not attempt to use it for any other purpose.Mount the engine in your model securely, following the manu

6The MAX-21RG Series has been developed for 1/8 scale off-road 'buggy' and scale cars.It provides a combination of performance and value tha

8NOTE:Where spacers are supplied joined in pairs (see sketch) separate them as shown. Either face may be placed downwards.Avoid forcing the screws. Se

10ASSEMBLY1.・・・2. Installing the element.・Slide the element base over the center tube (See Fig.1) and press down.If it is tight at the bottom, ap

12FURTHER PRECAUTIONSWhen removing the air cleaner, check the inside of the center tube and carburetor venturi. If any dirt is detected, this indicate

15CARBURETOR CONTROLSThe Needle-Valve:・The Mixture Control Screw:・The Throttle Stop Screw:For setting the minimum idling speed:・Three adjustable c

160.3∼0.5mmUse the same fuel as is to be employed for all initial running and containing NOT LESS THAN 18% lubricant. Temporarily remove the glowplug